Seite 1 von 1

Neue HPSDR Version von Pavel red-pitaya-alpine-3.6-armhf-20171025

Verfasst: Sa Okt 28, 2017 9:06 am
von DD8JM
Pavel hat am 25.10.2017 eine neue Version eingestellt, was neu ist weiß ich noch nicht, gesehen habe ist das:

normalize FIR filter coefficients in sdr_transceiver


Hier der Link zum Download:

https://github.com/pavel-demin/red-pita ... 171025.zip

Nach der Installation habe ich festgestellt, dass ich meine Rückführung ändern muste, ich habe weniger abdämpfen müssen, sprich ich brauchte mehr Leistung am RX2 für PureSignal.

73 Jörg

Re: Neue HPSDR Version von Pavel red-pitaya-alpine-3.6-armhf-20171025

Verfasst: Sa Okt 28, 2017 10:26 am
von DD8JM
Hello, Pavel,

thanks for your, as always, quick reaction.

I always install the latest versions immediately, so I also had red-pitaya-alpine-3.6 armhf-20170925 installed.

I had kept all the settings in PowerSDR and only changed the new SD card with the new software, after that the feedback was yellow.
So I reduced the attenuator in the feedback until I was again feedback green.

Thanks and greetings

Joerg

Re: Neue HPSDR Version von Pavel red-pitaya-alpine-3.6-armhf-20171025

Verfasst: Sa Okt 28, 2017 1:05 pm
von DD8JM
Hello, Pavel,

I tried it the other way round and put the old version back in. Result, I don't need to make any changes to the attenuator. I had expected the feedback to be blue, but this was not the case.

So I can say that there are no changes in PureSignal with the new version. Why it was like this the first time, I don't know.

Thanks again and best wishes

Joerg

Re: Neue HPSDR Version von Pavel red-pitaya-alpine-3.6-armhf-20171025

Verfasst: Sa Okt 28, 2017 8:21 pm
von DD8JM
I've upgraded to red-pitaya-alpine-3.6 armhf-20170925 again.
The area between feedback yellow-green and blue with different settings of the power had become too narrow,
so that I have to adjust my attenuation in the feedback again and again.

This is definitely not the case with the old version, why ever.

Maybe it's because of my configuration or my parameters in PowerSDR.

----------------------------------------------------------------

Ich habe doch wieder auf die Version red-pitaya-alpine-3.6 armhf-20170925 zurückgerüstet.
Der Bereich zwischen Feedback gelb grün und blau bei unterschiedlicher Einstellung der Leistung war bei mir zu schmal geworden,
so das ich mein Abschwächung in der Rückführung immer wieder anpassen muste.

Das ist mit der alten Version definitiv bei mir nicht der Fall, warum auch immer.

Vielleicht liegt es an meiner Konfiguration oder an meinen Parametern in PowerSDR.