Microphone audio ok with 192000 sample rate but no audio with 384000
Verfasst: Mo Apr 18, 2016 7:23 pm
Hi all. (I hope it is ok that I write also some English in your forum).
I have the RP running via ethernet fine. RX works well.
TX problem: I cannot get tx audio at all while using sample rate 384000 samples/sec in the Setup/Audio/primary dialog. When I set that sample rate to 192000 samples/sec it works. I would like to use 384000 samples/sek because then I can see at least the whole 20m band on rx (both cw and ssb segments of the band). Can you test and see if you experience the same on your system? In case, does anyone know why this happens?
(I have tested with two different USB headsets but not with soundcard and analog input yet).
I have the RP running via ethernet fine. RX works well.
TX problem: I cannot get tx audio at all while using sample rate 384000 samples/sec in the Setup/Audio/primary dialog. When I set that sample rate to 192000 samples/sec it works. I would like to use 384000 samples/sek because then I can see at least the whole 20m band on rx (both cw and ssb segments of the band). Can you test and see if you experience the same on your system? In case, does anyone know why this happens?
(I have tested with two different USB headsets but not with soundcard and analog input yet).